Response SL5 Bedienerhandbuch PDF herunterladen (Seite 36)

Confirm the new device ID code by sending

the Disarm signal from the same new Remote

Control or Remote Keypad within 15s as

follows…

Press on the Remote Control, or

Press

on the Remote Keypad.

The panel will produce three short beeps and

the LCD will show ‘Device Confirmed’.

The LCD will then show ‘Saving New Device’

while the ID code of the new detector is

stored into memory.

Deleting Linked Devices:

Scroll through the Zone menu until option ‘2.1

Remotes’ is displayed. The number of Remote

Controls/Keypads already linked will be shown,

(e.g. if there are two Remotes Controls and one

Remote Keypad linked the display will show

‘2.1 Remotes = 3’).

To delete all linked Remote Controls and Remote

Keypads press .

Press again within 15s to confirm and

actually delete all devices.

The display will now show ‘2.1 Remotes = 0’.

ALARM DURATION

Controls the alarm duration of the wireless, internal

control panel and wired sirens in the event of an

alarm, subject to the On/Off status of the wireless

and hard wired sirens which can be independently

controlled and disabled.

Scroll through the system menu until ‘2.2 Alarm

Time’ (and the current setting) is displayed.

Siren Duration

Default setting: 180 seconds

To change the setting press .

Enter the required Alarm Duration in units of

10 seconds (0 - 60).

e.g. enter 6 for a 60 seconds alarm duration.

minimum setting = 0. (i.e. 0 seconds / no

alarm).

maximum setting = 60 . (i.e. 600 seconds

or 10 minutes).

Press to save new setting and exit, or

Press to exit without saving.

Note: Following an alarm, the Siren will continue

to sound until either the system is Disarmed; or

the Alarm Duration time expires. If the ‘3 minute

alarm time limit’ of the Siren is enabled, then the

Siren will shut down after 3 minutes even if the

Control Panel siren is still sounding.

ENTRY/EXIT DELAY PERIOD

This sets the time entry and exit delay time period for

the system. The exit delay is the period between

arming the alarm and any detectors being allowed to

initiate an alarm (either instant or delayed). On

entering the property it sets the period between

triggering a detector configured as “delayed” and the

alarm occurring.

Default setting: 30 seconds

Scroll through the system menu until ‘2.3 Entry/Exit

Delay’ (and the current setting) is displayed.

Note: If the confirmation signal is not

received within 15s the control panel will

produce a single long beep and exit the

learning process. The learning process

will need to started again to learn the

new device into memory.

Note: If delete all is not confirmed within

15s then the action will be cancelled and

the Remote Controls/Keypads will not be

deleted and the display will revert to its

original setting.

Keypad User Access Code

? ? ? ?

ENTER

ESC

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 63 64

Kommentare zu diesen Handbüchern

Keine Kommentare

Response SL5 Bedienerhandbuch Seite 36

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Response SL5