Response SL5 Bedienerhandbuch PDF herunterladen (Seite 40)

LEARN DETECTOR CODE

(zones 1-32 only).

Allows a wireless detectors ID code to be learnt and

linked to the selected wireless zone.

Linking a New Detector to the Zone:

Note: There can only be one detector on each

zone so if a detector is already linked then linking

a new detector will replace the existing one.

To learn a new detector ID code and link it to the

selected zone press .

The panel will now listen for a valid signal from

a new detector to link to the zone.

The Panel will remain in Learn Mode for

30s. If a valid signal is not received from a

new detector within 30s it will automatically

exit Learn Mode and return to the top of

level 3.1.

Activate the Tamper Switch on the PIR/MAG

detector or trigger a smoke detector via its

test button.

If the detector is new and not already linked

on any security zone the panel will produce

two short beeps and the display will show

‘New Device’ and the type or the detected

device; (e.g. PIR, MAG or Smoke).

Confirm the new device ID code by activating

the Tamper Switch on the same new PIR/MAG

detector or triggering the same smoke detector

with its test button within 15s.

The panel will produce three short beeps

and the LCD will show ‘Device Confirmed’.

The LCD will then show ‘Saving New

Device’ while the ID code of the new

detector is stored into memory.

Deleting an Existing Device:

If a detector is already linked then the display

will show the detector type, for example:

‘3.1 Zxx: PIR’. The detector can be removed

from the system and its ID code erased from

memory without replacing it as follows:

To delete the current detector from the zone

press .

Press again within 15s to confirm and

actually delete the device.

The display will now show ‘3.1 Zxx: empty’.

xxxxx = PIR, MAG or Smoke, empty

3.1 Znn: xxxxx

Edit->Enter

3.1 Znn: xxxxx

1->Del Learn->3

1 = Delete or

3 = Learn

Confirm Delete

YES->1 3->NO

Delete confirmed

within 15s?

Device Deleted

Wait...

1 = Delete

press 1 to confirm delete

press 3 to cancel

15s time-out or auto cancel

display for 3s

YES

Send Code

waiting 30s...

Signal

received within 30s

from detector not

yet linked to

any zone?

New Device

xxxxx

Resend Code

waiting 15s...

Detector code

confirmed within

15s?

Device Confirmed

xxxxx

Saving

New Device

display for 3s

YES

display for 3s

Note: If the detector is already linked

to the control panel on any other zone

then the panel will produce a single long

beep and the received signal from the

detector will be ignored.

Note: If the confirmation signal is not

received within 15s the control panel will

produce a single long beep and exit the

learning process. The learning process

will need to be started again to learn the

new device into memory.

Note:

If delete all is not confirmed within

15s then the action will be cancelled and the

device will not be deleted and the display will

revert to level 3.1 as before.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 63 64

Kommentare zu diesen Handbüchern

Keine Kommentare

Response SL5 Bedienerhandbuch Seite 40

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Response SL5