Response SA5 E Betriebsanleitung PDF herunterladen (Seite 9)

Fit two 18mm No. 4 screws into the top holes until

almost fully home and hang the Control Panel over

the screws using the two keyhole slots in the top

corners of the panel casing.

Route the cable from the Power Supply Unit up

behind and on the right hand side of the Control

Panel and connect the plug to the DC power

socket in the panel. Ensuring that the cable is not

trapped between the Control Panel and the wall.

Fix the Control Panel to the wall using two 18mm

No. 4 screws in the lower two fixing holes in the

Control Panel and tighten the upper fixing screws

until they just grip the casing. Do not over tighten

the fixing screws or this may damage the casing.

Ensure that the ‘Reset’ and the ‘Hard-Wired Siren

tamper detect’ jumper links are set in the OFF position.

Connect battery leads to both back-up batteries

and refit batteries.

Battery 1 (left): Red lead to + battery terminal

Blue lead to – battery terminal

Battery 2 (right): Blue lead to + battery terminal

Black lead to – battery terminal

Important: Take care when connecting battery

leads to the batteries as connecting incorrectly

could damage the batteries or the Control Panel.

Note: The Power LED may flash to indicate that

the unit is being operated from the back-up

batteries and that mains supply is not present.

If fitted, remove the plastic film covering the LCD

display and on the display window on the cover.

10.

Close the lid of the Control Panel and tighten the

captive fixing screws.

11.

Plug in and switch ON the Power Supply Unit, (the

Power LED should illuminate).

12.

If required, connect the Control Panel to the

telephone line using the cable supplied by

inserting small RJ11 plug into socket marked LINE

located on the bottom edge of the Control Panel.

Connect the BT plug on the other end of the lead

to an appropriate telephone outlet.

If the cable supplied is not long enough to reach a

suitable phone point then it will need extending

using a coupler and extension lead (not supplied).

Inside view of Control Panel

GND

N.C.

N.O.

GND

V+

OUT

GND

B+

TAMP

Power Supply

Cable Route

+ Terminal

(Red Lead)

Terminal

(Blue Lead)

Upper

Keyhole

Fixing Hole

Lower

Fixing

Hole

External Tamper Switch

Jumper Link P51

Upper

Keyhole

Fixing Hole

+ Terminal

(Blue Lead)

Reset

umper

Link P1

Power

Supply

Jack

Socket

Terminal

(

Black Lead)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Response SA5 E Betriebsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Response SA5 E