Response SL2 Betriebsanleitung PDF herunterladen (Seite 12)

12

ADDING A NEW REMOTE CONTROL OR

KEYPAD TO THE SOLAR SIREN

11. Put the siren into Learn Mode by pressing the

“Learn” button for 5 seconds until the Siren emits

a single short beep and the both the indicator

LEDs and Learn LED will flash together slowly

once every 2 seconds.

12. To program the Remote Control’s ID code into

the Siren:

a) Press the button on the new remote

control.

If the Remote Control is new and not already

linked the siren will produce two short low

volume beeps and the Indicator/Learn LEDs

will start flashing together rapidly, (once

every second).

b) Confirm the new device ID code by pressing

the button on the same new Remote

Control within 15 seconds.

The siren will produce three short low

volume beeps and the Indicator/Learn LEDs

will stop flashing and remain ON for 3

seconds after which it will go out.

13. To program the Remote Keypad’s ID code into

the Siren repeat step 11:

a) Press

on the new Keypad.

If the Remote Keypad is new and not already

linked the siren will produce two short low

volume beeps and the Indicator/Learn LEDs

will start flashing together rapidly, (once

every second).

b) Confirm the device ID code by pressing

on the Keypad within 15 seconds.

The siren will produce three short low

volume beeps and the Indicator/Learn LEDs

will stop flashing and remain ON for 3

seconds after which it will go out.

The new Remote Control is now linked to the

Siren and its ID code recorded into the

Sirens memory.

The siren will now return to Service Mode.

14. Refit the battery cover and tighten the screws.

Do not over tighten the screws as this may

damage the thread.

15. If this is a new installation, mount the Siren onto

the wall as follows:

IMPORTANT: In order to communicate with the

Siren, the ID code of the Remote Control/Keypad

needs to be learned by the Siren. Whenever the

Siren is being set-up it will automatically enter

Service Mode when it is powered-up, ready to

learn a new Remote Control/Keypad. Alternatively

if the Siren is already in Operating Mode, see

page 19 to place the Siren into Service Mode

before adding a new Remote Control/Keypad.

Note: If the Remote Control is already

linked to the siren or if there are already

the maximum 6 Remote Controls/

Keypads linked to the siren then the siren

will produce a single long low volume

beep and exit Learn Mode. The Learn /

Indicator LEDs will stop flashing.

Note: If the Remote Keypad is already

linked to the siren or if there are already

the maximum 6 Remote Controls/

Keypads linked to the siren then the siren

will produce a single long low volume

beep and exit Learn Mode. The Learn /

Indicator LEDs will stop flashing.

Note: If the confirmation signal is not

received within 15s the Indicator /Learn

LEDs will stop flashing and turn off and

the siren will produce a single long low

volume beep and exit Learn Mode.

,

New Keypad User Access Code

? ? ? ?

,

New Keypad User Access Code

? ? ? ?

1

Note: If the confirmation signal is not

received within 15s the Indicator/Learn

LEDs will stop flashing and turn off and

the siren will produce a single long low

volume beep and exit Learn Mode.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare