Response SL8 Bedienerhandbuch PDF herunterladen (Seite 11)

2. Press the button on the new Remote

Control or

Press

on the Remote Keypad.

If the Remote Control/Keypad is new and not already

linked the panel will produce a two short beeps and

the next available zone LED will start flashing, (once

every second).

3. Confirm the device ID code by pressing the

button on the same new Remote Control within

15 seconds or

using the Keypad, confirm by pressing

The panel will produce three short beeps and

the zone LED will stop flashing and remain ON.

The ID code of the new Remote Control/Keypad

is now stored in memory ready for saving.

4. Press to save new settings and return to

step1 or press to exit without saving.

5. If after adding a remote, no more remotes

require linking then press to exit Learn

Mode.

To delete all linked Remote Controls/Keypads

rom the Control Panel:

1. Place the Control Unit into Learn Mode. With

he system in Standby

Press

The Arm and Part-Arm LEDs will illuminate and all

Zone, Fire and Tamper LEDs will flash together.

2. Press on the Control Panel.

3. Press

All illuminated zone LEDs indicating linked

devices will start flashing, (once every second).

4. Press again within 15 seconds to confirm

and erase the device links.

The flashing zone LEDs will extinguish.

5. Press to save new settings and return to

step1 or press to exit without saving.

6. If after deleting a remote, no more remotes

require deleting then press to exit Learn

Mode.

TESTING THE CONTROL PANEL AND

REMOTE CONTROL

1. Arm the Control Panel by pressing the

button on the Remote Control.

The Zone LED will illuminate for a few seconds

to indicate which zones are being armed. As the

entry/exit delay expires the Control Panel will

slowly beep and the Arm LED will flash. Towards

the end of the delay the beep rate will increase.

When the entry/exit delay is completed the

beeping will stop and the Arm LED will stop

flashing and be constantly illuminated.

2. Disarm the system by pressing the button on the

Remote Control.

The Control Panel will beep twice and the Arm

LED will turn OFF.

Keypad User Access Code

? ? ? ?

Keypad User Access Code

? ? ? ?

ENTER

Note: If the Remote Control/keypad is already

linked to the control panel or if there are already

the maximum 6 Remote Controls/Keypads linked

to the control panel then the panel will produce a

single long beep and the signal from the new

Remote Control will be ignored.

Note: If the confirmation signal is not

received within 15s the LED will stop

flashing and turn off. The panel will exit to

the top level of Learn Mode without saving

any changes. The learning process will

need to started again to link the new device.

Note: If the erase is not confirmed within

15s the LEDs will stop flashing and remain

illuminated. All links will remain intact and

will not be erased.

ESC

ENTER

ESC

ENTER

, ,

User Access Code

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Response SL8 Bedienerhandbuch Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Response SL8