Response SL8 Bedienerhandbuch PDF herunterladen (Seite 17)

Note: A maximum of 3 PIR or MAG detectors can be

linked to each alarm zone. A detector cannot be

linked to more than one zone.

Place the Control Panel into Learn Mode as follows:

With the system in Standby

ress

The Arm and Part-Arm LEDs will illuminate and

all Zone, Fire and tamper LEDs will flash

together.

1. To add/delete detectors on zone 1 press

and follow the process below

or for zone 2-6:

For zone 2 press and follow the

process below.

For zone 3 press and follow the

process below.

For zone 4 press and follow the

process below.

For zone 5 press and follow the

process below.

For zone 6 press and follow the

process below.

The Tamper LED will flash continuously to

indicate the system is in device Learn Mode.

The current number of PIR/MAG Detectors already

linked into zone 1/2/3/4/5 or 6 will be indicated on the

zone LEDs. For example if there are two detectors

linked, then zone LEDs 1 and 2 will be illuminated.

The panel will now listen for valid signals from new

PIR or MAG detectors to link to the zone.

To link a new PIR/MAG Detector to the

ontrol Panel:

2. Activate the Tamper Switch on the new

PIR/MAG detector.

If the detector is new and not already linked on

any security zone the panel will produce two

short beeps and the next available zone LED will

start flashing, (once every second).

3. Confirm the new device ID code activating the

Tamper Switch on the same new PIR/MAG

detector within 15 seconds.

The panel will produce three short beeps and

the zone LED will stop flashing and remain ON.

The ID code of the new PIR/MAG detector is

now stored in memory ready for saving.

4. Press to save new settings and return to

step1 or press to exit without saving.

5. If after adding a detector, no more detectors

require adding, then press to exit Learn

Mode.

To delete linked PIR/MAG Detectors from a

zone on the Control Panel:

1. Follow step 1 in Learn Mode if not already

entered.

2. Press

All illuminated zone LEDs indicating linked

devices will start flashing, (once every second).

LEARNING ZONE DETECTORS

ENTER

User Access Code

Note: The Panel will remain in Learn Mode for

30s. If a valid signal is not received from a

PIR/MAG within 30s it will automatically exit

Learn Mode and return to the top level of

Program Mode..

Note: If the detector is already linked to the

control panel (on any zone) or if there are

already the maximum 3 detectors linked to

the specific alarm zone then the panel will

produce a single long beep received signal

from the detector will be ignored.

Note: If the confirmation signal is not received

within 15s the flashing LED will stop flashing

and turn off. The panel will exit to the top level

of Learn Mode without saving any changes.

The learning process will need to start again to

learn the new device into memory.

ENTER

ESC

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Response SL8 Bedienerhandbuch Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Response SL8