Response SA1 E Betriebsanleitung PDF herunterladen (Seite 8)

1. Undo and remove the xing screw from the bottom

edge of the Keypad and remove the wall mounting

plate.

2. Using the mounting plate as a template, mark the

positions of the two xing holes on the wall. A small

spirit level will ensure it is perfectly level.

The Keypad is powered by a PP3 Alkaline battery

which under normal conditions will have an expected

life of approximately 1 year. When the battery level

drops, the “LOW BATT” LED on the front of the Keypad

will ash. When this occurs the battery should be

replaced as soon as possible.

POSITIONING THE KEYPAD

The Keypad is suitable for mounting in dry interior

locations only.

The Keypad should be located within a protected area

so that it cannot be reached by an intruder without

opening a protected door or passing through an area

protected by a PIR Movement Detector.

The Keypad should be mounted in a position close to

the main entrance door so that the User Access Code

can be entered and the alarm system shut down within

the 15 seconds entry time period.

Note: DO NOT x the Keypad onto or very close to

metalwork (e.g. radiators, water pipes, etc) as this

could affect the radio range of the device.

INSTALLING AND CONFIGURING THE

KEYPAD

Note: If adding a Keypad to an installed system,

ensure that the Siren is in Service Mode before

commencing installation, (see page 19). Remember

to switch the Siren back to Operating Mode after

installation is complete, (see page 19).

3. Fix the mounting plate to the wall using the two

18mm No.4 screws and 22mm wall plugs as required,

(a 5mm hole will be required for the wall plugs). Do not

over-tighten the screws as this may distort or damage

the mounting plate.

Note: The wall plugs supplied with the product are not

suitable for plasterboard walls, if mounting the Keypad

onto plasterboard use appropriate wall plugs.

4. Undo and remove the four xing screws in the rear

of the Keypad and remove the rear cover.

5. Located on the circuit board above the battery clip is

a row of 8 DIP switches. These switches set the House

Code for the Keypad and must be set to the same

ON/OFF combination as the DIP switches in all other

system devices.

6. Ensure that the jumper link located in the top left

corner of the circuit board is removed for use with this

alarm system, the link can be discarded.

7. Connect the PP3 alkaline battery to the battery clip.

8. Replace the rear cover and ret xing screws. Do

not over-tighten the xing screws.

9. Ret and secure the Keypad onto the wall mounting

plate. Do not over-tighten the xing screw.

Note: The Keypad is supplied with a User Access Code

of: “1234”. For security reasons, this code should be

changed to another 4 digit number which only you and

other users of the system should know.













 















































1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Response SA1 E Betriebsanleitung Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Response SA1 E