Response SL5 Bedienerhandbuch PDF herunterladen (Seite 11)

Note: It is recommended that the telephone

connection lead is not extended beyond 10 metres

before connecting to a telephone master or

secondary outlet.

DO NOT fix the Control Panel onto or very close

to metalwork (i.e. radiators, water pipes, etc) as

this could affect the radio range of the device.

INSTALLING THE CONTROL PANEL

1. Undo the two cover fixing screws on top of the

panel and open the cover. The cover is hinged

along the bottom edge.

2. Unclip and remove the two back-up batteries on

either side of the panel.

3. Hold the Control Panel in position on the wall

and mark the positions of the four fixing holes.

Remove the panel, drill four 5mm holes and fit

the 22mm wall plugs.

Note: The wall plugs supplied with the product

are not suitable for plasterboard walls. If

mounting the Control Panel onto plasterboard

use appropriate wall plugs.

4. Fit two 18mm No.4 screws into the top holes

until 3mm protrudes from the wall face and

hang the Control Panel over these screws using

the two keyhole slots in the top corners of the

panel casing.

5. Route the cable from the Power Supply Adaptor

up behind and on the right hand side of the

Control Panel and connect the plug to the DC

power socket in the panel. Ensuring that the cable

is not trapped between the panel and the wall.

6. Fix the Control Panel to the wall using two 18mm

No.4 screws in the lower two fixing holes in the

Control Panel and tighten the upper fixing

screws until they just grip the casing. Do not

over-tighten the screws as this could damage or

distort the casing.

Inside View of Control Panel

Upper Keyhole

Fixing Hole

– ve Terminal

(Black Lead)

+ ve Terminal

(Red Lead)

Reset Jumper

Link P1

Power Supply

Jack Socket

Upper Keyhole

Fixing Hole

+ ve Terminal

(Red Lead)

– ve Terminal

(Black Lead)

Lower Fixing

Hole

External Tamper

Switch Jumper

Link P51

Power Supply

Cable Access

Hole

T1 T2 GND T3 T4 N.C. CN.O.GNDGND BUZ BUTTAM P GND B+ V+ OUT GND

Do not drill the fixing holes with the Control

Panel in position; as the resulting dust and

vibration may damage the Control Panel’s

internal components and invalidate the

guarantee.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 63 64

Kommentare zu diesen Handbüchern

Keine Kommentare

Response SL5 Bedienerhandbuch Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Response SL5