Response SL5 Bedienerhandbuch PDF herunterladen (Seite 31)

FACTORY SETTINGS

USER CODE SETUP

Master User: 1234

Users 1-6: Not programmed

Duress Code: Not programmed

SYSTEM SETUP MENU

Alarm Duration: 3 minutes

Entry/Exit Delay period: 30s

Entry Delay Beeps: On

Exit Delay Beeps: On

Wireless Siren: On

Wired Siren: Off

Auxiliary Relay: Off

Jamming Detection: Off

Zone Lockout: On

Time: 12:00

Date: 01/01/07

Dial Mode: Off

Remote Phone Access: Off

Rings To Answer Phone: 6

REMOTE MANAGER SETUP

Phone Numbers 1 and 2: Not programmed

System ID Code: Not programmed

VOICE DIALLER SETUP MENU

Phone Numbers 1-4: Not programmed

Messages: Not programmed

ZONE SETUP MENU

Zone defaults set according to detector type

identified during learning process:

PIR/MAG Detectors

Zone Name: No name

Zone Type: Intruder

Zone Mode: Zones 1-2: Delayed

Zones 3-36: Instant

Part-Arm 1: Zones 1-4: On

Zones 5-36: Off

Part-Arm 2: Off

Chime: Off

Smoke Detectors

Zone Name: No name

Zone Type: Fire

Zone Mode: Instant

Part-Arm 1: Off

Part-Arm 2: Off

Chime: Off

FACTORY SETTINGS

LATCH KEY SETUP

Status: OFF

Selected User Setup: OFF (all users)

Phone Numbers: Not programmed

ANSWER PHONE SETUP

Status: OFF

User status: All Off

User ID messages: Not recorded

Phone Numbers: Not programmed

SPECTRA LIGHTING SETUP

Set Light-On Period: 3 Minutes

Spectra Mode: OFF

Stop Time: 06:00

Start Time: 18:00

RESET FACTORY SETTINGS

1. Press

This puts the system into Test Mode.

2. Undo the Control Panel cover fixing screws and

open the cover.

3. Remove the DC power jack, then remove and

disconnect one of the back-up batteries.

4. Set jumper link P1 to the ON position.

5. Reconnect the power supply jack.

6. The Control Panel will now reset itself with all

factory settings.

‘EEPROM RESET’ will be displayed while the

factory settings are restored to memory. Once

the memory reset has been completed ‘DISARM

READY’ will be displayed.

7. Reconnect and replace the back-up battery.

8. Reset jumper link P1 into the OFF position.

9. Close the Control Panel cover and refit the fixing

screws.

ENTER

, ,

User Access Code

OFF ON

Jumper Link

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 63 64

Kommentare zu diesen Handbüchern

Keine Kommentare

Response SL5 Bedienerhandbuch Seite 31

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Response SL5