Response SA1 E PLUS Betriebsanleitung PDF herunterladen (Seite 20)

Disarming the System

The system can be disarmed using either the

Remote Control or the Remote Keypad as follows:

Remote Control:

ress the button.

he Siren will acknowledge the Disarm signal by

eeping twice unless beep disable has been set.

Remote Keypad:

Press

The Siren will acknowledge the Disarm signal by

beeping twice unless beep disable has been set.

Personal Attack (PA) Alarm

A full Alarm condition can be immediately initiated

at any time (whether the system is Armed or

Disarmed) in the event of threat or danger by

activating a Panic Button on either the Remote

Control or the Remote Keypad.

Remote Control:

Slide the Panic Button upwards.

Remote Keypad:

Press and hold and buttons together

for more than 2 seconds with LED flashing

rapidly.

To enable or disable the panic function, follow

the below steps in sequence:

Disabling the Panic:

1. Press

2. Enter

3. Press , the LED will illuminate

once and flash twice

4. Press

5. Press , the LED will illuminate

once and flash three times to confirm the

setting has been accepted.

nabling the Panic:

1. Press

. Enter

. Press , the LED will illuminate

once and flash twice

4. Press

5. Press , the LED will illuminate

once and flash three times to confirm the

setting has been accepted.

Device Tamper

If the battery cover of any device (except a Remote

Control) is removed or if the Siren or Remote

Keypad are removed from the wall then an Alarm

will immediately occur (unless the Siren is in Service

Mode), even if the system is Disarmed.

The Alarm will sound until the set alarm duration

time expires or the system is Disarmed from the

Remote Control or Remote Keypad.

Battery Monitoring

All system devices continuously monitor their

battery condition. When a low battery indicator is

activated the device will continue to operate

normally for up to 2 weeks (depending upon system

use). However, the battery for that device should be

replaced as soon as possible.

Note: Before replacing the battery in any device

switch the system into Service Mode as previously

described. When the batteries have been replaced,

the system should be returned to Operating Mode.

The low battery indication for each system device is

as follows:

Remote Control:

When the Remote Control is operated under low

battery conditions the transmit LED will continue to

flash after the button has been released.

Under normal battery conditions the LED will

extinguish within 2 seconds of the button being

released.

User Access Code

? ? ? ?

User Access Code

? ? ? ?

User Access Code

? ? ? ?

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Response SA1 E PLUS Betriebsanleitung Seite 20

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Response SA1 E PLUS