Response SA1 E PLUS Betriebsanleitung PDF herunterladen (Seite 22)

Your alarm system requireds very little maintenance.

However, a few simple tasks will ensure its continued

reliability and operation.

IMPORTANT: If, for any reason you have to completely

power-down the Solar Siren (e.g. to move the

system to new premises), first put the system into

Service Mode before removing the Siren cover and

disconnecting the main rechargeable and initial power-

up batteries. Ensure that the solar panel is covered

with a lightproof material to prevent it being energised;

otherwise the solar panel may still power the siren.

Solar Siren

1. It is recommended that the Solar Panel on the top of

the siren housing should be cleaned at least twice

a year, preferably in the spring and autumn, using

a soft damp cloth. Do not use abrasive, solvent

based or aerosol cleaners. Do not attempt to clean

inside the unit or allow water to enter the unit.

This will ensure that the Solar Panel does not

become affected by the build up of excessive dirt

and receives all the available light.

2. The Solar Siren should not be left for long periods

with the batteries connected, unless the unit is

able to receive sufficient light to maintain the

battery charge. Failure to maintain charge to the

unit will result in the rechargeable battery running

unacceptably low. Should this occur, the unit

must be recharged from a 7.5 V dc/100mA supply

(e.g. from a mains adaptor power supply). When

re-powering the Siren fit a new 9V PP3 leak proof

Alkaline power-up battery to ensure that the Solar

Siren receives sufficient power until the solar

panel can recharge the main battery.

3. The main rechargeable battery has a typical life

of 3-4 years and needs no maintenance during

this period, provided the battery is kept charged.

The battery will be damaged if it is stored in a

discharged state for long periods.

IMPORTANT: Before removing the Solar Siren

from the wall ensure that the Siren is first switched

into Service Mode to prevent the Tamper Switch

operating and triggering an alarm (see page 19).

The Siren must be switched back into Operating

Mode otherwise the system cannot be Armed.

Detectors, Remote Control

and Remote Keypad

The detectors require very little maintenance. The

batteries should be replaced once a year or when a

low battery status is indicated.

Batteries

Note: Before removing the battery cover on any

device to replace the battery ensure that the Solar

Siren is switched into Service Mode to avoid

triggering an alarm.

The specifications for replacement batteries are as

follows:

Note: Where applicable only fit 9V PP3 Alkaline

type batteries. Rechargeable batteries should NOT

be fitted.

Disposal and Recycling

Disposal of this product is covered

by the Waste Electrical or Electronic

Equipment (WEEE) Directive.

It should not be disposed of with

other household or commercial

waste.

At the end of its useful life the packaging and

product should be disposed of via a suitable

recycling centre. Please contact your local authority

or the retailer from where the product was

purchased for information on available facilities.

DO NOT BURN.

The Rechargeable Batteries contain Sulphuric Acid

– DO NOT ATTEMPT TO OPEN THE CASING.

Maintenance

Remote Keypad 1 x 9V PP3 Alkaline

Remote Controls 1 x 3V CR2032 Lithium Cells

(or equivalent)

Magnetic Contact 2 x 3V CR2032 Lithium Cells

Detectors (or equivalent)

PIR Movement 1 x 9V PP3 Alkaline

Detectors

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Response SA1 E PLUS Betriebsanleitung Seite 22

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Response SA1 E PLUS