Response SA1 E PLUS Betriebsanleitung PDF herunterladen (Seite 8)

There are two jumper links located above the

battery compartment.

J2 jumper link: Reset to Factory default

J3 jumper link: System type selection

Jumper link J3 must be set as shown.

Connect the 9V PP3 Alkaline battery to the

battery clip.

Replace the rear cover and refit fixing screws.

Do not over-tighten the fixing screws.

Refit the Remote Keypad by slanting 45° onto

the wall mounting plate. Do not over-tighten the

fixing screw.

Note: The Remote Keypad is supplied with a default

User Access Code of: 1234. For security reasons, it

is recommended that this code is changed to

another four digit number which only you and other

users of the system know.

Note: Use thumb and middle finger to hinge off the

cover. The Remote Keypad has a back light illumination

facility. It will illuminate for 5 seconds when opening

the cover or pressing any key.

Inputting the House Code

n order to prevent any unauthorised attempt to

perate or disarm your system, you must configure

our system to accept radio signals only from your own

ystem devices. This is done by setting a series of

eight miniature (DIP) switches in all devices to the same

ON/OFF combination (The House Code) selected by the

user/installer. For security reasons, the Keypad does not

include a DIP switch, but house code setting is essential.

To input the house code, press the following keys in

sequence:

Press

Enter

Press , the LED will illuminate once

and flash twice

Press

Press , the LED will illuminate once

and flash three times to confirm the setting has

been accepted.

For example: if the house code set on the devices

reads as: 12578. It means the Dip Switch numbers

1, 2, 5, 7, 8 are set to the “ON” position, while 3, 4, 6

are set to the “OFF” position. Apply the Dip Switchs

set in “ON” positions for house code inputting.

Resetting to Factory Default

If you forget the User Access code, you can reset the

User Access code to factory default by following the

steps below:

Remove the battery.

Press and hold any key for more than 1 second.

Set the Jumper link J2 as shown in Fig. b below.

System Type

Jumper

ink J3

eset

Jumper

Link J2

nti-Tamper

Switch

J 3

User Access Code

? ? ? ?

House Code set on Devices

? ? ? ?

1 J 2

Fig . a

Fig . b

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Response SA1 E PLUS Betriebsanleitung Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Response SA1 E PLUS