Response SA1 E PLUS Betriebsanleitung PDF herunterladen (Seite 7)

ncluded in SA2 E system, available as

an optional accessory for the SA1 E,

SA1 E PLUS and SA1PF E systems.

The Wireless Remote keypad is used to control the

system by using a four digit User Access Code.

The Remote keypad incorporates Panic and anti-

tamper protection features that will immediately

initiate a Full Alarm condition when activated. Any

attempt to open the casing of the Remote keypad

will immediately initiate a Full Alarm condition even if

the system is disarmed, (unless the system is in

Service mode). In addition if a sequence of more

than 16 incorrect key presses is entered the Remote

keypad will be disabled for the next 1 minute. During

this 1 minute duration the LED will keep flashing

slowly. Consecutively disabled for 3 times, the Remote

Keypad will emit the tamper signal to the Siren.

The Remote Keypad is powered by a 9V PP3 Alkaline

battery. Under normal operating conditions this will

provide an expected life in excess of 1 year. When

the battery level falls below an acceptable level, the

“LOW BATTERY” indicator on the front of the Remote

Keypad will flash. When this occurs the battery

should be replaced as soon as possible.

Positioning the Remote Keypad

The Remote Keypad is rated IP44 and suitable for

mounting outdoors. The Remote Keypad should be

mounted in a position close to the main entrance door

so that the user access code can be entered easily.

Ensure that the position selected for the Remote

Keypad is within the effective range of the Siren.

Note: DO NOT fix the Remote Keypad to metalwork

locate the unit within 1m of metalwork (i.e.

radiators, water pipes, etc) as this could affect the

radio range of the Remote Keypad.

Installing and Configuring

the Remote Keypad

Ensure that the Siren is in Service mode.

Undo and remove the fixing screw from the

bottom edge of the Remote Keypad and remove

the wall mounting plate

Using the mounting plate as a template, mark the

positions of the four fixing holes on the wall.

Note: To make the best use of anti-tamper

protection you must insert a wall plug and screw

in the specified hole (as illustrated).

Fix the mounting plate to the wall using the

screws and wall plugs provided, (a 5mm hole will

be required for the wall plugs). Do not over-

tighten the fixing screws as this may distort or

damage the mounting plate.

Note: Installing the Remote Keypad against a flat

and smooth wall is of great importance so as to

avoid the tamper switch being falsely triggered.

Note: The wall plugs supplied with the product

are not suitable for plasterboard walls, if

mounting the Remote Keypad on to plasterboard

use appropriate wall plugs.

Undo and remove the two fixing screws in the rear

of the Remote Keypad and remove the rear cover.

Remote Keypad

Anti-Tamper

Protection

Fixing

Screw

Wall Mounting Plate

1 2 3

4 5 6

7 8 9

Arm

Disarm

elay-Arm 1

Delay-Arm 2

ow Battery

Indicator

LED

ransmit

Indicator

LED

ey Pressed

Confirmation

Indicator LED

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Response SA1 E PLUS Betriebsanleitung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Response SA1 E PLUS