Response RE3000S Betriebsanleitung PDF herunterladen (Seite 12)

WIRELESS PASSIVE

INFRA RED DETECTOR(S)

One Passive Infra Red Detector is supplied in the

standard RE5000S package. However, additional

Passive Infra Red Detectors can be purchased

separately, if required. Passive Infra Red Detectors

are designed to detect movement within a protected

area. The Detector element detects differences in

the infra red radiation when a person moves within

the protected area. If movement is detected, a radio

signal is transmitted to the Control Unit to activate

the alarm.

The recommended position for a Passive Infra Red

Detector is in the corner of a room mounted between

1.8m and 2m from the floor. At this height, the

detector will detect movement up to 5m at 180° and

14m at 110°. Also, in this position, the 180°/110° fan-

shaped detection patterns can normally offer greater

protection than mounting on a flat wall. Before

selecting a position for a Passive Infra Red Detector,

the following points should be noted:

1. Do not position a Detector facing a window or

direct sunlight. Passive Infra Red Detectors

are not suitable for use in conservatories, or

draughty areas.

2. Do not position a detector directly above any

source of heat, eg. fire, radiators, boiler, etc.

3. Where possible, keep pets out of areas protected

by Passive Infra Red Detectors. If this is not

possible, alternative mounting arrangements may

be required.

4. Where possible, mount the Detector such that

the logical path of an intruder would cut across

the fan patterns rather than directly towards the

Detector to obtain best detector sensitivity.

SETTING THE WIRELESS PASSIVE

INFRA RED DETECTOR(S)

Any number of Passive Infra Red Detectors can be

used with your system, providing they are all coded

with the system ‘House Code’ and are within radio

range of the Control Unit. To set the Passive Infra

Red Detector, proceed as follows:

10 RE5000S Professional Alarm System

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Keine Kommentare

Response RE3000S Betriebsanleitung Seite 12