Response RE3000S Betriebsanleitung PDF herunterladen (Seite 13)

ENSURE THAT THE CONTROL UNIT IS STILL IN

TEST MODE.

1. Remove the battery cover by sliding it down

and pulling it forward. DO NOT USE A SCREW

DRIVER.

2. Using a ball-point pen, set the miniature switches

1-6 inclusive to the pre-determined House Code.

3. Determine the Zone on which each Detector is

to operate and set miniature switches 7 and 8 to

correspond to the required Zone. (Refer to

System Zoning page 9).

4. Fit the 9 volt alkaline battery supplied to the

battery terminals.

Note: As soon as the battery is connected, a

two-tone chime will be emitted from the Control

Unit siren and the appropriate Zone LED will

flash for 3 seconds. This confirms that the

‘House Code’ and Zoning is correct.

5. With the battery cover off, hold the Detector at

the proposed installation position, press and

release the anti-tamper microswitch. Providing

the proposed location is within radio range of the

Control Unit, the two-tone chime will be repeated.

After the battery has been connected for approx 60

seconds the Infra Red Detector will become active

causing the Control Unit to give a two-tone chime

every time movement is detected.

6. Leave the battery cover off, remove the battery

and proceed to mount the Detector as described.

7. Leave the Control Unit in Test mode.

MOUNTING THE WIRELESS PASSIVE

INFRA RED DETECTOR(S)

1. Remove the screw (in the battery compartment)

holding the wall bracket to the Detector.

2. Slide the bracket down and remove the wall

bracket from the Detector as shown.

3. Hold the wall bracket in position and mark the two

mounting holes. (For corner mounting drill pilot

holes in the wall bracket chamfers as shown).

4. Drill two 4mm diameter holes and insert the

plastic wall plugs supplied.

5. Screw the wall bracket to the wall using the

screws supplied.

6. Position the Detector on the locating pin and slide

down, then fix the Detector to the wall bracket

using the holding screw.

Note: The normal detector mounting position is with

the battery compartment downwards. However, if the

detector is fitted in a room where pets have access,

mount the Detector with the battery compartment

upwards at a height of 1m from the floor. This will

shorten the detection range but allow pets to move

about the floor area without activating the Detector.

TESTING THE WIRELESS PASSIVE

INFRA RED DETECTOR(S)

ENSURE THAT THE CONTROL UNIT IS STILL IN

TEST MODE.

1. Refit the battery in the Detector but do not replace

the cover. The Control Unit will emit a two-tone

chime and the Detector LED will illuminate for a

60 second ‘warm up’ period.

2. During the ‘warm up’ period, leave the protected

area and ensure that no movement takes place in

this area for at least 60 seconds. Now, by walking

into the protected area the Detector LED will flash

and the Control Unit will emit a two-tone chime

each time the Detector senses movement. This

‘Walktest’ facility will enable you to check that

movement can be detected in all areas of the room.

3. Once the detection range has been verified, refit

the battery cover ensuring that the battery lead

wires are not trapped in the process.

RE5000S Professional Alarm System 11

PIR - fixings for corner mounting

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 33 34

Kommentare zu diesen Handbüchern

Keine Kommentare

Response RE3000S Betriebsanleitung Seite 13

Kommentare zu diesen Handbüchern