Response RE3000S Betriebsanleitung PDF herunterladen (Seite 19)

general use of the system to be via this second code

(eg. for children, guests, cleaners etc) and to retain

the Main User Access Code for your personal use in

re-programming the system. To change the Main

User Access Code:-

With the Control Unit in programming mode Enter

. No Zone LED’s will be illuminated.

Enter your new Access Code.

The Zone LED’s 1-4 will illuminate as each digit is entered.

Press to memorise the setting and to revert to

Programming mode.

6. DOOR-CHIME ZONE

It is possible to programme the Control Unit to emit a

two-tone ‘door-chime’ tone when a Magnetic Detector

is opened, with the system in Disarmed mode. This

facility may therefore be used to monitor Entry/Exit

doors when the system is not armed. The facility is

Zonal, ie: if there are 2 Magnetic Detectors on one

Zone, both detectors will operate the chime tone. It is

not possible to use PIR Detectors or the Zone 6 Hard

Wired input to generate the chime tone.

To set the Zone(s) on which the chime will operate

make a note of the Zone of the appropriate magnetic

detector(s) and proceed as follows:-

With the Control Unit in Programming mode Enter

. The Zone LED’s 1-6 will indicate the

status of each Zone:-

Zone LED ‘ON’ = Door-Chime ‘ON’ Zone

Zone LED ‘OFF’ = Door-Chime ‘OFF’ Zone

Factory default:-

Zone 1 Door-Chime ‘ON’

Zone 1 LED ‘ON’.

To add or delete a door-chime Zone press the

number of the Zone to illuminate or extinguish the

appropriate Zone LED.

Press to memorise the setting and to revert to

the Programming mode.

7. ENTRY DELAY TIME

When entering an entry delay Zone with the system

Armed or Part Armed, the system will be inactive for a

preset Entry Delay time to allow you time to disarm

the system by entering your access code at the

Control Unit, or using the Remote Control.

During the entry delay period, the Control Unit

sounder will emit an intermittent bleep tone and the

appropriate Zone LED(s) will flash to indicate that the

system has been triggered by a delay Zone detector.

With the Control Unit in Programming mode, Enter

A Zone LED will illuminate to indicate the setting

Factory default:-

30 seconds - Zone 3 LED ‘ON’.

To change the setting press the appropriate key to

illuminate the associated Zone LED:-

Press to memorise the setting and to revert to

the Programming mode.

8. PART ARM ZONE OMIT

Any of the Zones 1-6 can be omitted (ie inactive)

when the system is Part Armed. This will enable you

to arm only the selected (active) Zones when you Part

Arm the system.

With the Control Unit in Programming mode Enter

the Zone LED’s 1-6 will illuminate to

indicate the Zones which are omitted (inactive) when

the system is Part Armed:-

Factory default:-

Zone 1 omitted - Zone 1 LED ‘ON’.

To add or delete an omitted Zone, press the number

of the Zone to illuminate or extinguish the appropriate

Zone LED.

Press to memorise the setting and to revert to

the Programming mode.

RE5000S Professional Alarm System 17

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 33 34

Kommentare zu diesen Handbüchern

Keine Kommentare

Response RE3000S Betriebsanleitung Seite 19

Kommentare zu diesen Handbüchern