Response RE3000S Betriebsanleitung PDF herunterladen (Seite 21)

thereby ensuring that the signal is correctly

received. For full details of the setting and operation

of the optional Medical Alert Pendant refer to the

instructions supplied with the unit.

To programme the Siren Code into the Control Unit,

with the Control Unit in Programming mode Enter

. The Zone LED’s 1-8 will

indicate the Siren Code switch setting selected for

each 2 position switch as follows:-

Switch set ‘ON’ - Zone LED ‘ON’

Switch set ‘OFF’ - Zone LED ‘OFF’

Factory default:-

All switches set to ‘ON’ - all LED’s ‘ON’.

To enter/change the Siren Code, refer to the miniature

switch 1-8 settings previously set in your Solar Siren

& Strobe (and /or Medical Alert Pendant(s) and enter

the setting of each switch in turn as follows:-

For switch set ‘ON’ press

For switch set ‘OFF’ press

For example; for Siren Code:-

The Zone LED’s 1-8 will indicate the new Siren Code

switch setting selected for each switch 1-8 as

follows:-

switch ‘ON’ - LED ‘ON’

switch ‘OFF - LED ‘OFF’

Press to memorise the Siren Code setting and

to revert to the programming mode.

13. SECOND USER ACCESS CODE

The Control Unit is supplied with a Preset Second

User Access Code of .

This code allows Arming/Part Arming and

Disarming only at the Control Unit and may

therefore be entrusted to children, guests or

neighbours; or alternatively this code could be

used for day to day operation, with the Main User

Access Code reserved for re-programming only.

However you plan to use the system, for security

reasons it is essential that you change the Second

User Access Code to another four digit number

which only you and other users of the system will

know and use. (Again, a number with a personal

significance will be easier to remember).

With the Control Unit in Programming mode Enter

No Zone LED’s will be illuminated.

Enter your new Second User Access Code.

The Zone LED’s 1-4 will illuminate as each digit is

entered.

Press to memorise the setting and to revert to

the Programming mode.

Programming of your Control Unit is now

complete. Exit Programming mode by pressing

again.

EXTERNAL CONNECTIONS

The Control Unit incorporates a terminal block and

Communication Interface Cable to facilitate external

connection of a Hard-wired Siren, Telephone

Dialler/Communicator, or a Hard-wired Zone 6 Trigger

input. Before making any connections, ensure that

the memory link is in the ‘ON’ position and then

remove all power (mains and back up battery).

Note: Any unused cores of the interface cable must

be cut back; insulated or made safe to prevent

short circuits.

After making your external connections reconnect the

power supply and back-up battery and refit the

Control Unit to it’s wall fixing bracket.

Wiring interconnections should comply with the

appropriate requirements of BS4737 part 1 in respect

of cable type and installation methods.

Full details of the Control Unit terminal block

connections and Communicator Interface Cable

connection are shown overleaf:-

RE5000S Professional Alarm System 19

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

Kommentare zu diesen Handbüchern

Keine Kommentare

Response RE3000S Betriebsanleitung Seite 21

Kommentare zu diesen Handbüchern