Response SL5 Bedienerhandbuch PDF herunterladen (Seite 25)

(Optional)

The Control Panel incorporates a terminal block for

connection of a Hard-wired Siren. The connection

terminal block is located inside the Control Panel

behind the front cover. To access the terminal block

you must first put the system into Test Mode to

prevent an alarm occurring.

To do this:

Press

Undo the two fixing screws on the top edge of the

Control Panel and open the front cover.

Before making any connections, ensure that the

Reset Jumper Link P1 is in the ‘OFF’ position and

then remove the DC power jack and disconnect 1 of

the back-up batteries.

The signalling contacts on all hardwired alarm and

tamper zones must be volt free. (i.e. they must only

open and close and not apply any self generated

voltage across the contacts).

The contacts on zones 33, 34, 35 and the tamper

circuit should be normally closed. An alarm will be

triggered when the contacts open. On zones 33, 34

and 35, additional Wired Magnetic Door/Window

Contact Detectors can be hardwired to these

terminals (by purchasing the Response Wired

Door/Window Contact Accessory Pack (PW1).

The contacts on zone 36 should be normally open.

An alarm will be triggered when the contacts close.

Note: The External Tamper Switch jumper link P51

should be fitted into the ON position only if the

hardwired tamper circuit is used, otherwise it must

be in the OFF position.

After making your external connections reconnect

the power supply and back-up Battery. Then close

the Control Panel cover and tighten the fixing

screws on the top edge.

Press to leave Test Mode and return to Standby.

EXTERNAL CONNECTIONS

T1 T2 GND T3 T4 N.C. CN.O.GNDGND BUZ BUTTAMP GND B+ V+ OUT GND

Permanent

12Vdc power

supply output

(100mA max.)

Latching

relay contacts

(volt-free)

Hardwired Zone

Connections

(using normally

closed contacts)

Switched 12Vdc

output for

wired Siren

(300mA max.)

GND

N.C.

N.O.

GND

TAMP

GND

B+

V+

OUT

GND

Tamper circuit

connections for

wired Siren

Not Used

Terminal Block

External Tamper

Switch Jumper

Link P51

Reset Jumper

Link P1

TERMINAL BLOCK DETAIL

OFF ON

Jumper Link

Reset Jumper Link P1

Jumper Link

ENTER

, ,

User Access Code

ESC

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 63 64

Kommentare zu diesen Handbüchern

Keine Kommentare

Response SL5 Bedienerhandbuch Seite 25

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Response SL5